With VHT 80 I get connnections of 866 Mb/s on 5 GHz If that works you can set additonal channel width, when doing this it often reverts to auto channel, just toggle Upper/Lower save/apply and you can set the channel number. When setting up wireless settings always use a channel number do not use auto channel, choose your channel with Wifi analyser on your phone to see the best channel or use Status/Wireless/Site surveyĭepending on the client used you should get a connection of 72 to 144 Mb/s, which efectively gives you 2/3 of that. Setup manully do not restore from backup. The most important thing when coming from stock is to telnet into you router and do: To save in the R6400Backups directory I made on the usb drive.Īs a lot of people (including me) are using this build so there is probably something wrong in your settings. To backup partition 5 however my router sees the USB drive as USB_Storage thus i used:Ĭat /dev/mtd4 > /tmp/shares/USB_Storage/R6400Backups/mtd4_boarddata.bin At 4 f in your guide you say to issue :cat /dev/mtd4 > /tmp/shares/S_Drive/mtd4_boarddata.bin I was able to enable telnet w/o any program just in the debug page. I 'upgraded' my stock firmware before reading your guide an ended up with V1.0.3.66_10.0.50. I will be trying it in a bit on my R6400v2 with board_id=U12H332T30_NETGEAR. Posted: Tue 19:22 Post for a very nice install guide for the Netgear R6400v2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |